Application of double numerical control steel bar straightening hydraulic cutting machine and safety control reminder

Application and safety control reminder of hydraulic numerical control steel bar straightening and cutting machine. In many industrial fields, especially in the steel manufacturing industry, the hydraulic numerical control steel bar straightening and cutting machine is often used as an efficient steel processing equipment, which brings convenience to the production of many enterprises. So with the deepening of the application degree, this kind of equipment, especially the new type of steel bar cutter safety operation process is very important. As for the operation of the hydraulic numerical control steel bar straightening and cutting machine, we can start from the start-up of the equipment. The operator should check and confirm that the cutter has no crack, the bolt of the tool holder is tight, and the protective cover is firm. When manually turning the belt pulley, it is necessary to check whether there is any error in the gear meshing clearance. After the equipment is started, it should be idled for a while, so as to facilitate the inspection of whether the transmission parts and bearings can operate normally as expected, and then the formal operation can be carried out. During the operation of the hydraulic numerical control steel bar straightening and cutting machine, when the machine does not reach the normal speed, it is not allowed to cut the material. When cutting, the middle and lower parts of the cutter should be used, the steel bar should be tightly held at the edge of the cutting edge, and the operator should also stand on the side of the fixed blade to press the steel bar with force to prevent the end of the steel bar from popping out and injuring people. If the material is short, the operator should pay attention to use casing or clamp to press or clamp the short end of the reinforcement, and when the equipment shears low alloy steel, the high hardness cutter should be replaced. If any abnormal phenomenon occurs during the operation, stop the machine immediately for maintenance. Generally, experienced operators will pay attention to remove the debris between the cutters with steel brush after the equipment stops running, and clean and lubricate the whole machine.