Operation rules and matters needing attention of automatic numerical control steel bar hoop bending machine

1、 Check whether the mechanical properties are good, the worktable and bending machine table are level; and prepare various mandrel tool blocks.

2、 According to the diameter of processing steel bar and the requirements of hoop bending machine, install the mandrel, forming shaft, stop iron shaft or variable stop frame, and the diameter of mandrel shall be 2.5 times of the diameter of reinforcement.

3、 Check the mandrel, stop block and turntable to ensure no damage and crack. The protective cover shall be tight and reliable, and the operation can be started only after the normal operation of the empty machine is confirmed.

4、 During the operation, insert one end of the steel bar to be bent into the clearance provided by the rotary table, fix the other end close to the machine body and press it by hand, and check the fixation of the machine body,

It can be started only when it is installed on the side blocking the reinforcement.

5、 It is strictly forbidden to change the mandrel, change the angle and adjust the speed during the operation of the fully automatic numerical control reinforcement hoop bending machine, and it is not allowed to add oil or remove it.

6、 When bending the steel bar, it is strictly forbidden to process the steel bar diameter, number and mechanical speed beyond the mechanical regulations.

7、 When bending high hardness or low alloy steel bars, the limited diameter shall be changed according to the mechanical nameplate, and the corresponding mandrel shall be replaced.

8、 It is strictly forbidden to stand within the working radius of the bending steel bar and on the side of the fuselage which is not fixed. The bent semi-finished products shall be stacked in order, and the hook shall not be upward.

9、 When the rotary table changes direction, it must be carried out after it stops stably.

10、 After the operation, clean up the site, maintain the machinery and power off the lock box