Application and safety control tips of double numerical control steel bar straightening hydraulic cutting machine

Application and safety control tips of hydraulic numerical control steel bar straightening and cutting machine. In many industrial fields, especially in the steel making profession, the hydraulic numerical control steel bar straightening and cutting machine is often used as an efficient steel bar processing equipment, which brings convenience to the production of many enterprises. So with the deepening of the use of this kind of equipment, especially the new type of steel bar cutting machine safety operation process is very important. As for the operation of the hydraulic numerical control steel bar straightening and cutting machine, we can start from the start of the equipment. The operator should check in advance and admit that the cutter has no crack, the bolt of the tool holder is tight, and the protective cover is reliable. When rolling the belt pulley manually, pay attention to check whether there is any fault in the meshing clearance of the gear. After the equipment is started, it should be idle for a while. The purpose is to check whether the transmission parts and bearings can work normally as expected, which can be formally operated in the future. In the operation process of hydraulic numerical control steel bar straightening and cutting machine, when the machine does not reach the normal speed, it is not allowed to cut material. When cutting, the middle and lower parts of the cutter should be used, the steel bar should be tightly grasped and put into operation quickly. The operator should also stand on the side of the fixed blade to press the steel bar with force, so as to avoid hurting people when the end of the steel bar pops up. If the data is short, the operator should pay attention to the selection of casing or clamp to press or clamp the short end of the reinforcement, and when the equipment shears low alloy steel, the high hardness cutter should be replaced. If there is any abnormal phenomenon in the operation process, stop the machine immediately for maintenance. Generally, experienced operators will pay attention to remove the debris between the cutters with steel brush after the equipment stops running, so as to clean and smooth the whole machine.