Speed and bending of straightener

It is very important to adjust the distance between the upper and lower rollers and the speed when the straightener is working. In this way, four things need to be done to achieve good results in the process of using the straightener.

Observe the steel pipe carefully. When adjusting the straightener, make sure that the contact between the steel pipe and the machine is not too large or too small. Generally speaking, it is good to have the contact gap no more than 0.1 mm. If it is greater than 0.1 mm, the correction effect will not be particularly good.

The speed of the straightener should be adjusted according to the bending degree of the steel pipe and the material of the steel pipe. The parameters of the straightener used for different steel pipes are different. Therefore, we must pay attention to the speed of the straightener. What's more, it's about the accuracy of the requirements. I'm going to adjust its speed in this way.

‍‍It is appropriate to adjust the distance between the upper and lower rollers of the straightener according to the material of the pipe material, its bending degree and accuracy, especially the distance between the upper and lower rollers, which should be adjusted by a professional master. The adjustment of the distance between the upper and lower rollers can improve the speed on the one hand and help the equipment work on the other hand. The proper distance between the upper and lower rollers can ensure a better working effect.

In the process of using the straightening machine, never touch the steel pipe in motion with your hands. For example, if there is a problem with the equipment or some special circumstances occur, some people may not be able to touch the steel pipe, which is very dangerous. Especially when a girl is operating the straightener, never let her hair fall down. I must go to tie it up Hair and a good headgear. A kind of

In the process of using the straightening machine, if the straightening amount of the straightening machine is too small, then the distance between the steel plate and the steel plate can not meet the deformation requirements all the time, and I need us to increase some procedures. If the reduction is too large, the straightening effect of the straightening machine will be quite good, but it will cause some residual stress on the steel plate.

From the perspective of the use of the machine, it will also speed up the wear of the straightener. In other words, there are some roller sticking accidents at the end of the steel plate. Therefore, in the process of using the straightener, although we must pay attention to the reduction, the straightening reduction is within a reasonable range. A kind of

another factor of the straightener's bending deformation and curvature value is the equipment itself. For example, the parameters of the equipment may be poor, or the accuracy of the equipment itself is not high, which will make the bending deformation and curvature value difficult to meet our requirements. When we choose again, we also have to choose some suitable manufacturers' products. In fact, Mr. I still needs us to understand all kinds of details of the manufacturer. If you don't understand it, the straightening reduction of your own purchase is not particularly good.