Solution of double NC steel bar straightening hydraulic cutting machine without cutting tool

1、 Solution:

1. Check whether there is a good size, move the front contact according to the size, and the steel bar will be cut off automatically when it reaches the contact position;

2. If the contact has been adjusted and the size is accurate, but it is still not cut in place, it is the circuit between the contact and the digital control box that has a problem, resulting in slow response, so the switch is in place.

2、 The structure of the machine is that the high-speed rotor rotates to adjust the angle of the straight wire die, so as to achieve the effect of straightening, and then thread the wire forward through the threading wheel. After reaching the required size, push the runway forward 5 mm after touching the positioning key, and the upper punch presses the vertical wire cutter to cut off immediately. The wire presses the open bearing through the pressure plate on the vertical wire cutter, and the wire will automatically fall to the wire holder. If you want to change the length, move the positioning key.